Azbil AZ-1SHM - Page 5

- iii -
CAUTION
Do not touch live terminals.
Doing so may cause an electric shock.
Use this device within the specied operating temperature range (−20 to 50 ºC) and
humidity range (5 to 95 % RH).
If used outside the above range, this device may malfunction, making communication
with connected devices unreliable.
Do not use this device near a magnetic eld. A magnetic eld may cause a malfunction,
making communication with connected devices unreliable.
Do not allow water or dust to enter this device. Doing so may cause an electric shock.
The jacket cannot perfectly protect this device from water or dust.
Remove the batteries if this device will not be used for a long time.
Otherwise, battery uid might leak and injure someone.
Connect only USB-compatible devices to the USB port. Otherwise, there is a danger of
re or damage to the device.
Before sending a HART signal via the 1SHM, check to make sure that sending a
HART signal to the connected system and eld devices will not cause any problems.
Communication may cause uctuation in analog values (4–20 mA), leading to unexpected
behavior of the equipment.
If other HART hosts are connected at the same time, interference between the device
and host primary or secondary HART communication may occur, resulting in a HART
communication error. Monitor communication between the device and other hosts by
using the Support Tool in passive mode before sending the HART signal from the 1SHM
and, if needed, change the settings to avoid simultaneous communication.
Before using SFN/DE communication from model CFS100 eld communication software,
make sure that the eld device connected to it is not in operation. Communication may
cause uctuation in analog values (4–20 mA), leading to unexpected behavior of the
equipment.
Before using the Support Tool in HART master mode, check to make sure that sending
a HART signal to the connected system and eld devices will not cause any problems.
Communication may cause uctuation in analog values (4–20 mA), leading to unexpected
behavior of the equipment.