Azbil MagneW Neo PLUS - Page 204

Operation using the data setting device Azbil Corporation
6-20 Model MTG11A/18A, MTG11B/18B, MTG14C
Step Key Procedure
4 • In the case of a system with
digital output, press the
key here.
Press the key.
• In the case of a system
with analog output, press
the key here.
Result and branch:
• The following screen appears and a communication between
the SFC and converter can be started. Go to step 6.
• If the TAG No. has not been entered in the converter, the
TAG No. displays as XXXXXXXX. Go to step 5.
5 Here, TAG No. can be entered. For a detailed procedure, see
“Entering TAG No.: ID key” on page 6-21.
If there is no need to enter a TAG No., go to step 6.
6
Press the key. The following screen appears.
This screen is the basic standby screen. When starting
operation, confirm that the following screen has appeared.
SHIFT
A
ID
DE READ
SHIFT
SFCM00006002D
A
ID
DE READ
SFCM00006006D
SFCM00006072D
A
ID
DE READ
SFCM00006008
SFCM00006007D
CLR
( No )
CLR
( No )
SFCM00006009D
CM2-MTG300-2001.book 20 ページ ２０１５年９月２９日 火曜日 午前１０時１４分