Need help?Do you have a question about the Azkoyen t3 hopper and is the answer not in the manual?
General| Power Supply | 24V DC |
|---|---|
| Interface | RS-232 |
| Hopper Capacity | 2000 coins |
| Coin Diameter Range | 16mm - 31.5 mm |
| Counting Speed | 12 coins per second |
| Supported Currencies | Multiple (configurable) |
Details installation steps, connector types, and hardware address setup for the hopper.
Configuring the hopper's address using hardware connections on the main connector.
Specifies operating temperature, humidity, and installation distance requirements.
Covers dimensions, weight, coin range, capacity, and user ergonomics.
Details power supply, current draw, and connector types for the hopper.
Explains control boards, coin detection, and sensor functions.
Describes the coin extraction mechanism and the speed of coin payout.
Covers coin presence, level detection, and security features against manipulation.
Details the Cctalk protocol, address configuration, and coin type settings.
Explains the parallel protocol, working modes, and status LED indications.
Step-by-step guide for dismantling and reassembling the T3 hopper.
Instructions for cleaning the optic sensor and configuring mechanical coin ranges.
Guides on fitting optic sensors to set minimum and maximum coin levels.
Overview of tools like HEUS and TL20 for software updates and configuration.
Introduces Cctalk Manager, USB, RS232, and IS21 interfaces for simulation and control.
To Next Page
