Baby Lock BL3-407 - Fitting the Motor

Belt
cover
screws
(Figure
1)
Mount the
motor correctly onto
the
machine
body
as
follows:
Remove
the
belt cover by
loosening both
belt
cover
screws
(Figure
1).
Mount
the motor
onto the
machine
body by
tightening
the
bracket
f ixing screw
while
setting
the V-belt
in
place
at
the same time,as
shown
in Figure
3.
(The
bracket
fixing screw,
washer
and V-belt
are enclosed together
in the
carton).
Belt
tension
will be most
suitable
when the
V-belt
bends slightly
under
finger
pressure
(see
Figure
4). Make
belt tension
adjustments
by shifting
the
position
of the
belt
tension
adjusting
nut accordingly
(Figure
4).
Re-attach
the belt
cover.
(Figure
4)
Belt
tension
adiustinq
fixing
screw
uE@\
Bracket
{ixing screw
(Figure
2)
(Figure
3)
2