Baby Lock Crafter's Choice BLCC2 - Care and Maintenance; Cleaning the Machine Surface; Cleaning the Race

100
APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Care and Maintenance
Simple sewing machine maintenance operations are described below.
Cleaning the machine
surface
If the surface of the machine is dirty, lightly soak a
cloth in neutral detergent, squeeze it out firmly, and
then wipe the surface of the machine. After cleaning it
once with a wet cloth, wipe it again with a dry cloth.
Cleaning the race
Sewing performance will suffer if dust collects in the
bobbin case; therefore, it should be cleaned
periodically.
1
Turn off the sewing machine.
2
Unplug the power cord from the power supply
jack on the right side of the sewing machine.
3
Remove the flat bed attachment.
4
Grasp both sides of the needle plate cover,
and then slide it toward you.
1 Needle plate cover
X The needle plate cover is removed.
5
Remove the bobbin case.
Grasp the bobbin case, and then pull it out.
1 Bobbin case
● Unplug the power cord before cleaning
the machine, otherwise injuries or an
electric shock may occur.
CAUTION
● Unplug the power cord before cleaning
the machine, otherwise injuries or an
electric shock may occur.
CAUTION
a
1