Selecting Stitching 77
3
Example: Bus
Saving stitch settings
This machine is preset with the default settings for the
stitch width (zigzag width), stitch length, thread
tension, programmed thread cutting, and automatic
reverse/reinforcement stitching for each stitch.
However, if you wish to save specific settings for a
stitch so that they can be used later, press after
changing the settings to save the new settings with
the selected stitch.
This feature can be used only with utility stitches.
To use a stitch length of 2.0 mm for the
straight stitch
Press .
• To reset the selected stitch pattern to its
default settings, press , and then press
.
X The confirmation message is displayed.
To Next Page
Loading...
