Baby Lock imagine wave BLE3ATW - 2-Thread Overlock; 2-Thread Overlock and Flatlock

The rolled edge setting is used to achieve the narrowest stitch possible (1.5mm) on your Baby Lock serger.
The stitch is suitable for seaming sheer and lightweight fabrics and for edging and hemming lightweight fab-
rics.
R
O
L
L
E
D
E
D
G
I
N
G
23
Rolled Edging
3-Thread Rolled Edge
With the stitch selector set on "D", a narrow hem will become a rolled edge. The fabric edge rolls around the
stitch finger.
The upper looper wraps the fabric edge while the lower looper thread is nearly invisible on the
back side of the stitch formation.
Remove the left needle and thread. Clear the stitch fingers.
Turn the stitch length adjusting dial counter-
clockwise into the rolled hem range at 1.5 setting (fig. A). Set the stitch wid
th dial to 3.5 "M" (fig. B).
For a 3-thread rolled edge, Move the stitch selector lever to "D".
M
6
.
0
3
.5
3
.
0
M
6
.
0
3
.5
3
.
0
A
B
C
D
B
C
D
O
O
A
B
A
NEEDLES
right
LENGTH
1.5R
WIDTH
3.5
STITCH
SELECTOR
D
WAVE
SELECTOR
O