2 – 5 Threading Method II – Manual
If thread breaks or is allowed to run out, it will be necessary to rethread manually. A threading diagram is
conveniently located on the inside of the front cover of the machine.
It is important that manual threading
be done in the following sequence:
A. Upper looper
- Place the first thread on the
third spindle of the thread holder. Beginning with its corresponding “eye”
on the telescopic thread guide, thread all
green color – coded thread guides, including the tension
disc, and end with the upper looper.
B. Lower looper
- Place the next thread on the
far –right spindle and thread in the same manner following the blue
color – coded
path and end with the lower looper. When threading the lower looper, please refer to
figures 10a through 10c below.
8
Downloaded from www.Manualsoncd.com
To Next Page
Loading...
