Attention: Turn power switch OFF ("O")
before inserting or removing the bobbin.
Press the needle position button to raise the
needle before inserting or removing the
bobbin.
1. Open the hinged cover.
2. It is important to be sure that the bobbin is
turning in a clockwise direction (arrow).
3. Hold the bobbin case with one hand. Insert the
bobbin so that the bobbin turns in a clockwise
direction.
4. Pull the thread through the slot, to the left and
then right until it enters the delivery eyelet
under the tension spring.
INSERTING THE BOBBIN
INSERTING THE BOBBIN
23
2
1
4
3
To Next Page
Loading...
