26
3. Place the thread through the appropriate
thread guide opening for the spool pin that is
being used.
4. Guide the thread into the pre-tension thread
guide pulling the thread through the pre-
tension spring as illustrated.
5. Pull the thread downward from the thread guide.
6. Draw the thread down through the right slot
and around the tension dial from the right to
left. Pull the thread up to insert it between the
tension disks and under the wire loop of the
check spring.
7. Bring the thread up through the left slot and
then into the slotted eye of the take-up lever
from right to left. Continue by bringing the
thread back down through the left slot.
3
4
5
6
7
To Next Page
Loading...
