Baby Lock Quest BLQ2 - CORDING; Single cording; Triple cording

Mark the design on the fabric. Insert the cord in
the center groove of the cording foot from the
right side opening. Pull the cord about 5cm (2
inches) behind the foot.
The grooves under the foot will hold the length
of the cord in place while the stitches are being
form over the cord.
Select the stitch and adjust the stitch width so
that the stitches are just covering the cord.
Lower the foot and sew slowly, guiding the cord
over the design.
Single cording
Sew over one strand of cording to create a pretty swirled design on a jacket or vest or sew over
three strands of cording for border trims. Pearl cotton, knitting yarn, embroidery floss, lace thread,
fine wool or lily yarn can be used for cording.
Triple cording
Push the sewing thread to the left and insert
three cords into the grooves of the foot and pull
about 5cm (2 inches) of the cords behind the
foot.
Select the desired pattern and adjust the stitch
width so that the stitches are just covering the
cords. Lower the foot and sew slowly guiding the
cords.
CORDING
CORDING
RH
RH
71