LCD SCREEN
Getting Ready
29
1
Using the Machine Setting Mode Key
Press to change the default machine settings (needle stop position, embroidery speed, opening
display, etc.). To display the different settings screens, press for “Sewing settings”, for “General
settings”, for “Embroidery settings” or for “Wireless LAN settings”.
Sewing Settings
■ Page 1
a Select whether to use the sewing speed controller
to determine the zigzag width (page 127).
b Make adjustments to character or decorative
stitch patterns (page 168).
c Adjust the presser foot height. Select the height of
the presser foot when the presser foot is raised.
d Adjust the presser foot pressure. The higher the
number, the greater the pressure will be. Set the
pressure at “3” for normal sewing.
e When set to “ON”, the thickness of the fabric is
automatically detected by an internal sensor while
sewing. This enables the fabric to be fed smoothly
(pages 83 and 91).
■ Page 2
f Select whether “1-01 Straight stitch (Left)” or “1-
03 Straight stitch (Middle)” is the utility stitch that
is automatically selected when the machine is
turned on.
g Change the height of the presser foot when
sewing is stopped when the pivot setting is
selected (page 89). Adjust the presser foot to one
of the four heights.
h Change the height of the presser foot when the
machine is set to free motion sewing mode
(page 128).
i Adjust the amount of fabric feeding of the dual
feed foot (page 76).
j Pressing the “Start/Stop” button or depressing the
foot controller automatically lowers the presser
foot (if it is raised) before starting sewing. When
releasing the pedal of the foot controller or
pressing the “Start/Stop” button to stop sewing,
the presser foot will be automatically raised.
k Pressing the “Thread Cutter” button automatically
lowers the presser foot before cutting the thread.
The presser foot will be raised after the thread is
cut.
• Press or to display a different settings screen.
To Next Page
Loading...
