Baby Lock Solaris 2 - Using the Spool Stand

UPPER THREADING
66
h
Continue threading; however, do not pass
the thread in the needle bar thread guide
“6” on the needle bar. Thread the needle on
the right side.
a Needle bar thread guide
i
Press to unlock all keys and buttons.
j
Select a stitch pattern. (Example: )
* Refer to “Sewing a Stitch” on page 77 for selecting
the stitch.
* Refer to the “STITCH SETTING CHART” on
page 210 for the proper stitch to use with presser
foot “J”.
 The selected stitch is displayed.
k
Press , and then press to select the
twin needle mode.
 Twin needle mode is set.
l
Start sewing.
Sample of Twin Needle Sewing
Using the Spool Stand
The included spool stand is useful when using
thread on spools with a large diameter (cross-
wound thread). This spool stand can hold two
spools of thread.
■ Using the Spool Stand
• Be sure to use a spool cap that is slightly larger
than the spool.
If the spool cap that is used is smaller or much
larger than the spool, the thread may catch and
sewing performance may suffer.
Note
• If the key is light gray after selecting the
stitch, the selected stitch cannot be sewn in
the twin needle mode.
CAUTION
• Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
a
Memo
• To change direction when sewing with the
twin needle, raise the needle from the
fabric, raise the presser foot lever, and then
turn the fabric.
Memo
• Refer to page 25 to assemble the spool
stand.
• Refer to page 56 to wind the bobbin when
using the spool stand.