Baby Lock Solaris 2 - Setting the Stitch Length; Setting the L;R Shift

STITCH SETTINGS
86
Setting the Stitch Length
Follow the steps below when you want to change
the stitch pattern length.
Example:
Press to shorten the stitch length.
 The value in the display gets smaller.
Press to lengthen the stitch length.
 The value in the display gets bigger.
Setting the “L/R Shift”
Follow the steps below when you want to change
the placement of the zigzag stitch pattern by
moving it left and right.
Example:
Press to shift the stitch pattern to the left.
 The value in the display appears with a minus sign.
Press to shift the stitch pattern to the right side
of the left needle position.
 The value in the display appears with a plus sign.
Memo
• Press to save the stitch settings.
• Press to check changes made to the
stitch.
• Press to return the stitch length to
the original setting.
CAUTION
• If the stitches get bunched together, lengthen
the stitch length and continue sewing. Do not
continue sewing without lengthening the stitch
length. Otherwise, the needle may break and
cause injury.
Memo
• Press to save the stitch settings.
• Press to check changes made to the
stitch.
• Press to return to the original
setting.
Note
• After adjusting the “L/R Shift”, slowly rotate
the handwheel toward you
(counterclockwise) and check that the
needle does not touch the presser foot. If
the needle hits the presser foot, the needle
may bend or break.