Baby Lock Solaris 2 - Page 96

USEFUL FUNCTIONS
94
a
Select a stitch.
b
Press , make sure that “Temporary Stop”
in the machine settings screen is set to
“OFF”, and then press .
c
Press to set “Guideline” to “ON”. Set the
"Main" line horizontal position according to
the selected pattern. And then press .
d
Press .
e
Press .
f
Press to select whether or not
sewing is ended with a complete pattern.
If necessary, press after making your
selection.
g
With a chalk pencil, mark the fabric with
lines for sewing the pattern and for the end
of stitching.
Memo
• If is selected for [Sub], a grid will be
displayed.
Memo
• If appears in light gray and is not
available, the sewing end point cannot be
specified with the selected stitch pattern.
Select a different stitch pattern.
The length of the stitch pattern is adjusted
so that sewing will stop at the specified
end point with a complete pattern.
If this key appears in light gray and is not
available, this function cannot be used.
This adjustment may cause the pattern to
be sewn slightly stretched vertically.
The end of stitching is not adjusted. When
the end point is reached, sewing stops
immediately, even if the stitch pattern is
not complete.
Memo
• If “End Point Setting” is set to “ON”, the
pattern cannot be projected by the
projector.
• To cancel “End Point Setting”, set “End
Point Setting” to “OFF”, and then press
.