Baby Lock Solaris VISION BLSA3 - Page 164

STITCH SETTINGS SCREEN
162
■ Region Settings
a Shows/Changes the stitch type and color for the
selected region.
b Select the region to be changed.
c Shows/Changes the stitch settings for the
selected region.
d Save the pattern drawing data (.pm9) and
embroidery data (.phx).
e Proceed to embroidery edit screen.
Fill stitch settings
Stippling stitch settings
Decorative fill stitch settings
a
Use to select the line or region to be
changed.
 Each touch of moves the highlighting of the
selected pattern in order.
b
Select the setting to be changed, and then
change the setting in the screen that
appears. (In this example of a standard Fill
stitch, the angle of the stitches will be
changed.)
c
Touch [Manual], and then use to
change the direction.
d
Touch to apply the setting.
* Change other settings in the same way.
[Direction]
Specifies the embroidering direction. Select
[Manual] to change to the desired direction of
fill stitch.
[Density]
Specifies the stitch density of fill stitch.
[Pull
compensation]
Specifies to correct the shrinkage of the pattern
by slightly shortening or lengthening the stitching.
Change the setting after you test embroider the
pattern and can check the shrinkage.
[Under
sewing]
Select if you need or do not need the under
sewing for the stabilized fabric.
[Run pitch]
Specifies the length of a stitch of the
stippling stitch.
[Spacing]
Specifies the spacing between the stitches
when embroidering the stippling stitch.
[Distance] Specifies the offset from the pattern outline.
[Single/
Triple stitch]
Specifies the stitch type.
a
c
b
d
e
[Size]
Increases/reduces the size of the pattern.
[Direction]
Specifies the rotation angle of the pattern.
[Outline]
Select whether [ON] or [OFF]. The outline is also
converted to embroidery data. If [ON] is selected,
the number of thread jumps can be reduced.
[Random shift]
Randomly varies the line.
If a setting of 1 or more is specified for
[Random shift], a [Type] setting for the
[Random shift] can be selected.
[Position
offset]
Specifies the reference point for the pattern.
[Thickness]
Sets repeated or single stitching of the pattern.