Baby Lock Solaris VISION BLSA3 - Using the Embroidery Position Sticker to Align the Embroidering Position

CONFIRMING THE PATTERN POSITION
45
Embroidery Step by Step
1
k
Touch the orientation of the pattern by
touching the orientation keys until the grid
lines are parallel with the chalk mark drawn
on the fabric. (Refer to “Rotating the
Pattern” on page 59.)
a Center point of the pattern
l
Touch the positioning keys to move the
embroidery frame until the center point of
the pattern in the camera view window is
aligned with the chalk mark drawn on the
fabric.
m
Touch to return to the previous
screen.
n
Press the “Start/Stop” button to begin
embroidering.
* Refer to “Embroidering Patterns” on page 50.
Using the Embroidery Position
Sticker to Align the Embroidering
Position
The embroidering position can easily be aligned
using the machine’s built-in camera and the
included embroidery positioning sticker.
a
Touch to display the editing
window, and then touch .
b
Following message appears. Touch .
 The embroidering position will return to the original
position, even if you changed before.
a
Note
• Depending on the type of fabric that is used, a
part of the embroidery positioning sticker may
remain attached when it is peeled off. Before
using the embroidery positioning sticker,
check that it can be cleanly removed from a
scrap piece of the fabric to be used.