Baby Lock Solaris VISION BLSA3 - If the Thread Breaks During Embroidering

ADJUSTMENTS DURING THE EMBROIDERY PROCESS
53
Embroidery Step by Step
1
If the Thread Breaks during
Embroidering
a
If the upper thread is broken or runs out,
redo the upper threading.
b
Touch .
c
Press the “Presser Foot Lifter” button to
lower the embroidery foot.
d
Touch .
 The camera view window appears.
e
Touch or to move the needle back
the correct number of stitches before the
spot where the thread broke.
* If you cannot move back to the spot where the
thread broke, touch or
to select the color
and move to the beginning position of that color,
then use or to move ahead to slightly
before where the thread broke.
* Touch to enlarge the image in the screen.
* Touch to remove “ “ from the screen.
f
Touch to close the camera view
window.
g
Touch to return to the original
screen.
h
Press the “Reinforcement Stitch” button to
sew reinforcement stitches at the beginning
of sewing, and then press the “Start/Stop”
button to continue embroidering.
Memo
• If the bobbin thread is broken, follow the
directions in “If the Bobbin Runs out of
Thread” on page 52.