Baby Lock Solaris VISION BLSA3 - Before Embroidering

BEFORE EMBROIDERING
6
Follow the steps below to prepare the machine for embroidery.
BEFORE EMBROIDERING
Step 3
Step 1, 2
Step 7
Step 6
Step 4
Step 5, 8
Step 9
Step # Aim Action Page
1 Presser foot attachment Attach embroidery foot “W”. 9
2 Checking the needle Use needle 75/11 for embroidery. 11
3 Embroidery unit attachment Attach the embroidery unit. 13
4 Bobbin thread setup For the bobbin thread, wind embroidery bobbin thread and set it in place. 15
5 Pattern selection Turn the main power to ON, and select an embroidery pattern. 33
6 Fabric preparation Attach a stabilizer material to the fabric, and hoop it in the embroidery frame. 26
7 Embroidery frame attachment Attach the embroidery frame to the embroidery unit. 32
8 Checking the layout Check and adjust the size and position of the embroidery. 42
9 Embroidery thread setup Set up embroidery thread according to the pattern. 21