Troubleshooting
A-18
3
This message is displayed when (Twin needle) is set to “ON”, and a stitch pattern
that cannot be sewn with the twin needle is selected.
4
This message is displayed when the “Start/Stop” button was pressed while the foot
controller was connected.
5
This message is displayed when the buttonhole lever is down, a stitch other than a
buttonhole is selected, and a button, such as the “Start/Stop” button, is pressed.
6
This message is displayed when the buttonhole lever is up, a buttonhole stitch is
selected, and a button, such as the “Start/Stop” button, is pressed.
7
This message is displayed when a button, such as the “Start/Stop” button, was
pressed while the presser foot was raised.
8
This message is displayed when you tried to combine more than 70 decorative
stitches.
9 This message is displayed when the stitch mode was changed.
10 This message is displayed when you tried to delete a saved pattern.
11
This message is displayed when a button, such as the Reverse/reinforcement stitch
button, was pressed while the bobbin winder shaft is moved to the right.
Error Messages Cause/Solution
To Next Page
Loading...
