EasyManua.ls Logo

BabySafe Labrador - 1. Introduction; 1.1 Semi-universal ISOFIX CRS, Group 0+(birth-13 kg): Install child car seat with ISOFIX connector + Top tether; 1.2 Semi-universal CRS,Group 0+,I,II,III(birth-36 kg): Install child car seat with ISOFIX connector + 3 point safety belt

Default Icon
116 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
31
1. Introduction
1.1 Semi-universal ISOFIX CRS, Group 0+(birth-13kg):
Install child car seat with ISOFIX connector + Top tether
Notice
1. This is an ISOFIX CHILD RESTRAINT SYSTEM. It is approved to Regulation No.
44, 04 series of amendments for general use in vehicles tted with ISOFIX an-
chorages systems.
2. It will t vehicles with positions approved as ISOFIX positions (as detailed in
the vehicle handbook), depending on the category of the child seat and of
the xture.
3. The mass group and the ISOFIX size class for which this device is intended is:
Group 0+ (0-13kg), ISOFIX size class D.
This child restraint is classied for „Semi-universal” use and is suitable for xing into
the seat positions of the following cars:
Seat positions in other cars may also be suitable to accept this child restraint. If in
doubt, consult either the child restraint manufacturer or the retailer.
1.2 Semi-universal CRS,Group 0+,I,II,III(birth-36kg):
Install child car seat with ISOFIX connector + 3 point safety belt
This child restraint is classied for „Semi-universal” use and is suitable for xing into
the seat positions of the following cars:
Seat positions in other cars may also be suitable to accept this child restraint. If in
doubt, consult either the child restraint manufacturer or the retailer.
Only suitable if the approved vehicles are tted with 3 point safety belts, approved
to UN/ECE Regulation No. 16 or other equivalent standards.
FRONT REAR
Outer Centre
YES NO
NO
FRONT REAR
Outer Centre
YES NO
NO