Preparing your model
Please carefully remove the individual units out of the blister packaging. The units A and
B each come with a motor. However, only unit A (with pantograph) (Fig. 1) can be driven
individually for test purposes. Unit B only runs when connected with the other units.
Coupling the Units
The models are fitted with special electrically conducting couplings. Place the rail car unit
A (with pantograph) and intermediate car unit C at a slight distance from each other on
the rails. In general, always make sure when coupling two units that two different coupling
parts (with and without coupling hook) (H) as per (Fig.2) are facing each other.
Now carefully push the units
towards each other until the
couplings touch. We recom-
mend slightly raising the two
ends of the cars (about 2 cm)
from the rails and to rest the
coupling hook (H) as shown
in (Fig. 2a) on a finger. This
allows the two couplings to
be gently interconnected until
the coupling hook enga-
ges without one part being
pressed downwards.
Repeat the procedure to
couple the control cab car
unit B to the intermediate car
unit C.
Figure 1
Figure 2
Figure 2a
H
H
LILIPUT hopes that your DOMINO model will give you a lot of pleasure.
Unit B Unit C Unit A
To Next Page
Loading...
