BACHMANN EUROPE PLC
H0 1:87 15
Uncoupling the units
To uncouple ( Fig. 2 b ) press the
coupling hook (H) downwards
by using a screwdriver from the
side and separate the units.
The 3-part basic model of the
DOMINO can also be expanded
by adding the intermediate car
set units D, E ... to from a reali-
stic multiple unit.
The intermediate cars in the
multiple unit can be arranged in any fashion just like the original. The coupling arrangement
prevents units being connected contrary to a real-life situation.
Putting your DC model into operation
Once the units have been cou-
pled, the multiple unit is ready
to run.
The DC model in its default set-
ting has been connected so that
the power pick-up is effected via
the wheels of the two end cars.
If you like to change the default
setting it is possible as follows:
Three switches are located on
the main circuit board directly
under the roof of Unit A. To
operate these switches you must
pull the small resistor cover (W)
upwards (Fig. 3).
H
S1
S3
S2
W
Figure 2b
Figure 3
To Next Page
Loading...
