If you wish to run the car in block track
operation or have it automatically stop in a
terminus, please switch the switch S3 (Fig.
3) to the stop function. You can use Switch
S2 to select between wheel contact and
overhead line as power pick-up collector.
However, the stop function is not possible
in overhead operation with a pantograph.
The installed LED interior lighting is swit-
ched on in the default setting. Switch S1
can be used to switch the interior lighting
on or off as desired. This switch must be in
the „off“ position in digital operation. The
interior lighting is turned on and off here
with the decoder.
Installation of a DCC Decoder
The FLIRT model has a 21 + 2 pin decoder
interface ( D ). The installed interface board
contains the switching circuit for the stop
function. If you wish to convert to digital
operation by installing a decoder, the stop
function is deactivated.
To install a decoder, you do not need to
remove the housing of unit A. The interface
is located in front of the entry doors on the
top board directly underneath the large
resistor cover (G). This part is held by two
clip-in lugs and can be lifted upwards (Fig.
4).
To Next Page
Loading...
