8
Use and Care (Assembly)
To use your Blender Solution
™
5000, begin by assembling the glass mixing jar.
1. Position the rubber gasket down onto the circular flat surface in the
plastic blender or smoothie blade base.
2. Place the bottom threaded section of the glass mixing jar down into the plastic
blade base. Engage threads by twisting the blade base clockwise until tight
-
ened onto the jar. Make sure that the blade base is tightly fastened to the jar
and that the rubber gasket is properly compressed between the jar and the
plastic blade base.
3. Push the lid onto the top of the mixing jar. Place the clear lid cap in the center
of the lid or place the stir stick through the center of the lid.
4. Place the mixing jar onto the motor base so that the bottom of the blade base
is sitting flat on the motor base.
5. Plug in the cord. Your Blender Solution
™
5000 is now ready to use!
Glass Mixing Jar
Lid
Rubber Gasket
Blender Blade Base
Clear Lid Cover
ASSEMBLY
To Next Page
Loading...
Need help?
General
