Back to Basics SMOOTHIE CHOICE SM600 User Manual

ASSEMBLING YOUR SMOOTHIE CHOICE
™
Before assembling your Smoothie Choice
™
wash all parts, except for motor base in
warm, soapy water, rinse thoroughly and dry. Unscrew and disassemble the valve
for cleaning (see Cleaning Your Smoothie Choice
™
section). To prolong the life of
your smoothie maker, do not wash parts in the dishwasher.
1. Position the rubber gasket down onto the circular flat surface in the blade base.
2. Screw the blade base onto the bottom of the blending jar by twisting the blade
base clockwise until tightened. Make sure that the blade base is tightly fastened
to the blending jar and that the rubber gasket is properly compressed between
the blending jar and the blade base.
3. Press the lid onto the top of the blending jar. Press the clear lid cap in the
center of the lid or place the stir stick through the center of the lid if blending
liquids or frozen drinks.
4. Place the blending jar onto the motor base so that the bottom of the blade base
is sitting flat on the motor base.
5. Plug in the cord. Your smoothie maker is now ready to use.
Stir Stick
Lid
Blending Jar
Dispensing Valve
Rubber Gasket
Blade Base
4

Back to Basics SMOOTHIE CHOICE SM600 Specifications

General

Brand	Back to Basics
Model	SMOOTHIE CHOICE SM600
Category	Blender
Language	English