Put the Glass Table Top (A) on a flat surface.
Be careful not to damage the table top.
Insert the Table Top Bumper (J) into the Leg (B).
Insert the Leg (B) into the Leg Receiver.
Note: There are four leg receivers in the table
Attach the Upper Frame (C) to the
four Legs (B) with Bolts (E) and Nuts (F).
Don't cover the Nut Caps (G) now.
Caution: Do not tighten all the bolts
until you finish all the assembly.
Attach the Lower Frame (D) to the
four Legs (B) with Bolts (E) and Nuts (F).
Tighten all the bolts and nuts, and cover
Now please enjoy your new table.
Note: To use an umbrella with this table, please
remove the plastic centre ring and put the umbrella
pole through the table top and centre frame.
To Next Page