TF1008-011991-T ENG P. 7 22062011
WARNING
z Do not insert any tool or foreign object into the valve outlet or safety relief valve. You may
damage the valve and cause a leak. Leaking propane may result in explosion, fire, severe
personal injury, or death.
z Never attempt to attach this appliance to the self-contained LP gas system of a camper,
trailer or motorhome.
z The pressure regulator and hose assembly supplied with the appliance must be used.
Replacement pressure regulator and hose assemblies must be those specified by the
appliance manufacturer.
WARNING
z Do not use appliance until leak checked.
z If leak is detected at any time, STOP.
z If you cannot stop a gas leak, immediately close LP tank valve, leave area of appliance,
and call LP gas supplier or your fire department!
Leak Testing Valves, Hoses and Regulator
1. Turn all control knob(s) to OFF.
2. Be sure regulator is tightly connected to LP tanks.
3. Completely open LP tank valve by turning OPD hand wheel
counterclockwise. If you hear a rushing sound, turn gas off
immediately. There is a major leak at the connection. Correct before
proceeding.
4. Brush soapy solution onto indicated connections shown at right in A
and B.
5. If ‘growing” bubbles appear, there is a leak. Close LP tank valve
immediately and retighten connections. If leaks cannot be stopped, do
not try to repair. Call for replacement parts. Order new parts by giving
the serial number, model number and name of items needed to the
Customer Service Center at (888)837-1380 or email at
CustomerService@Rankam.com. Use only replacement parts
specified by manufacturer.
6. Always close LP tank valve after performing tank leak test by turning
OPD hand wheel clockwise.
Lighting Instructions
Do not lean over LP cooker while lighting.
1. Read all instructions before lighting.
2. Turn regulator control valve to OFF position.
3. Fully turn timer control knob clockwise.
4. Fully open LP bottle valve.
5. Light match and place it over burner. PRESS and HOLD
push button of safety valve. Slowly turn ON the regulator
control valve. DO NOT stand with head or arms over
cooker.
6. When burner is lit, still HOLD the push button for 10
seconds and then release.
7. If ignition does not occur in 5 seconds, turn the burner
control(s) off, wait 5 minutes, and repeat the lighting procedure.
Note: Cycle time for timer is around 15 minutes. If the timer is not reset within around 15 minutes,
the burner will shut OFF automatically. If this occurs, please follow lighting instructions and
continue to cook.
To Next Page
Loading...
General