Bad Boy 1025H - COOLANT LEVEL INSPECTION AND COOLANT REPLACEMENT; ANTIFREEZE

B25W-202010
3
-
9
CHAPTER 3 ENGINE ACCESSORIES1025H TRACTOR
3
When the radiator is hot after operation, be sure to wait until the coolant cools down sufciently before removing
the radiator cap.
If this is not done, heated vapor might burst out and cause burns. Use fresh water from a faucet as the coolant.
When the coolant is replenished or changed, let the engine idle for a while for the coolant to circulate sufciently
in the cooling system and replenish if necessary after stopping the engine.
When the radiator is hot after operation, be sure to wait until the coolant cools down sufciently before removing
the radiator cap.
If this is not done, heated vapor might burst out and cause burns. Use fresh water from a faucet as the coolant.
When the coolant is replenished or changed, let the engine idle for a while for the coolant to circulate sufciently
in the cooling system and replenish if necessary after stopping the engine.
- The radiator interior should be washed clean ahead of time.
- As concerns of mixing ratio of an antifreeze, follow its manufactures’ instructions.
- Antifreeze should be blended well with water before lling.
- When the coolant level is lowered due to evaporation, maintain the level by adding water, not by using an
antifreeze solution.
- When the coolant level is lowered due to leaks, maintain the level by adding an antifreeze solution of the same
mixing ratio.
- As antifreeze corrodes point, take care not to spill it on painted parts.
- The tractor is lled with a permanent type antifreeze (Mobile Long Life Coolant) when shipping (Mixing ratio : 50%).
1.7 DAILY INSPECTION
1.7.1 COOLANT LEVEL INSPECTION AND COOLANT REPLACEMENT
1.7.2 ANTIFREEZE
PRECAUTION FOR FILLING ANTIFREEzE