EasyManuals Logo

Bad Boy 40 Series User Manual

Bad Boy 40 Series
501 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
40BW-202010
1
-
18
CHAPTER 1 GENERAL INFORMATION 4025H/4035H/4035CH TRACTOR
(1) No.: TA00028501A (2) No.: NTE5220000C4
This structure’s
protective capability
may be impaired
by structural
damage, overturn,
or alteration.
If any of these
conditions occur,
the structure
must be replaced.
NTE5220000C4
K5FB=B;
(3) No.: TZE5770000B3
75IH=CB
TO AVOID PERSONAL INJURY(OPERATING ON SLOPES)
1. If descending a slope, never disengage the clutch or shift levers
to neutral.
Doing so could cause the tractor to speed up out of control.
2. Slow down for slopes, especially when transporting heavy,
rear mounted equipment.
3. Before descending a slope, shift to a gear low enough to
control speed without using brakes.
TZE5770000B3
Before operating this machine please read the operators manual
so that you fully understand how to operate this machine. Always
check the oil, coolant, and fuel levels before operating this unit.
Work in ventilated area.
Do not work long hours air conditioner, because it
make exhaust air. if you don't have an air cleaner,
open the door and get outside air into the area.
Lock the
joystick
Release
joystick
Back
TA00028501A
WARNING
Left
Right
Front
CAUTION
WARNING
Starting
1. Do not use a screwdriver or any other tool to jump the
starter as a means of cranking this unit.
2. The operator should only start this unit from the operators
station. Starting this unit anywhere other than the
operator's platform can cause serious injury.
3. When starting this unit it is critical to ensure that main shift
lever, range shift lever, and pto shift lever are all in the
neutral position.
4. While operating this unit always ensure that safety devices
are being used correctly. For example always wear your seat
belt and ensure that the pto cover is installed.
5. Never start this unit while others are close by. Only crank
and operate this unit once others are at a safe distance.
This
includes starting, operating implements, operating a loader,
or using a backhoe.
6. After starting this unit allow the tractor to idle five minutes
with the pto lever and the shift lever in the neutral position.
7. In cold weather allow the glow plugs to cycle through one
time before trying to start this unit.
Driving
1. When turning on a slope or uneven surface please reduce
your speed.
2. When traveling downhill please shift into low range before
you begin moving.
3. Do not operate this unit in narrow or unsafe places; the
potential for roll over could exist in these conditions.
4. When climbing a steep slope, always do so in reverse.
5. While driving the tractor make sure that the two brake
pedals are latched together, and do not engage differential
lock while moving.
6. The operator should be the only person on the tractor.
Carrying passengers on the tractor or implement can cause
serious injury.
7. Do not step on, or stand on pto cover at anytime. 8. Do not
suddenly stop, turn, or jump the clutch on this unit at
anytime. 9. While operating on a public road, always abide
by the law.
Operating
1. Use caution in wet conditions, turning suddenly can cause
the tractor to become stuck.
2. When operating this unit, always maintain a safe working
distance from others.
Parking
1. When parking the tractor make sure all implements or
attachments are on the ground before turning of the engine.
This includes the front end loader.
2. When parking on a slope always apply the parking break
and chock the tires.
Servicing
1. Before servicing this machine always turn the engine off
first.
2. When checking electrical components always disconnect
the negative terminal of the battery.
3. For information regarding service issues or service help
please contact you local dealer.
4. Always allow time for the radiator coolant to cool and
relieve pressure before removing the radiator cap.
When the joystick is not being used, always put
it in the locked position.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bad Boy 40 Series and is the answer not in the manual?

Bad Boy 40 Series Specifications

General IconGeneral
BrandBad Boy
Model40 Series
CategoryTractor
LanguageEnglish

Related product manuals