Bad Boy 40 Series User Manual

40BW-202010
1
-
43
CHAPTER 1 GENERAL INFORMATION
1
4025H/4035H/4035CH TRACTOR
5. Runtheengineforawhileandchecktheoilller
hole (3) and drain plug for oil leakage.
SPECIFIED AMOUNT OF
ENGINE OIL
4.3ℓ(1.14u.s.gal.)
LUBRICANTS Grade CJ or higher
F42W120A
8.2.9 REPLACING ENGINE OIL FILTER
1. Unscrew the filter element (1) and clean its
mounting surface.
2. Replace the O-ring on the surface which is to be
againstanewlter.
3. Applyathinlmofcleanoilaroundthesealring
ofanewlter.
4. Fitthenewlterandtightenitbyhand.
5. Starttheengineandcheckthelterbaseforoil
leakage.
6. Stop the engine and check the oil level. If the
level is too low, add more oil.
CAUTION

          -
ter not to damage the engine. Replace the

cooled down.
F42W121A

Bad Boy 40 Series Specifications

General

Brand	Bad Boy
Model	40 Series
Category	Tractor
Language	English