Bad Boy 40 Series User Manual

40BW-202010
1
-
45
CHAPTER 1 GENERAL INFORMATION
1
4025H/4035H/4035CH TRACTOR
8.2.12 CHANGING TRANSMISSION FLUID/HYDRAULIC OIL
4. Remove the drain plug (1).
F42W123A
1. Start the engine and activate several hydraulic
functions to increase oil temperature.
2. Park the tractor on level ground and lower the
implement onto the ground.
3. Stop the engine, remove the ignition key and
apply the parking brake. (Set the transmission
into the neutral state.)
F42W124A
5. Replace the transmissionuid/hydraulic oillter
element (2).
6. Before adding clean oil, replace the seal and
tighten the drain plug to 5 kg.m (36 lb.ft).
F42W126A
9. Wait for 10 to 15 minutes before checking the
oil level. The oil level should be on the mark on
thedipstick(4).Ifnot,addoiluptothespecied
upper limit.
F42W125A
7. Add transmission fluid/hydraulic oil into the
transmissioncasethroughitsllerhole(3).
8. Run the engine for a moment to activate the
hydraulic pressure function. Stop the engine.
TRANSMISSION FLUID/
HYDRAULIC OIL AMOUNT
37ℓ(9.77u.s.gal.)

Bad Boy 40 Series Specifications

General

Brand	Bad Boy
Model	40 Series
Category	Tractor
Language	English