SECTION 1: BASIC INFORMATION
Congratulations on the purchase of your new Bad Boy Mower! The purpose of this manual is to assist
operators in maintaining and operating their machine. The information and instructions in this manual can
help you attain years of performance from your new Bad Boy. Also, check out our website to learn more
about the Bad Boy family.
1.1 All Bad Boy engines use 10W30 engine oil.
1.2 All Bad Boy hydraulic systems use 20W50 engine oil.
1.3 All Bad Boy Mowers use hi-temp multi-purpose grease. NLGI No. 2 for the grease fittings.
1.4 ZT & MZ models have 12 psi in both front and rear tires.
1.5 Pups, AOS, and Diesel models have 12 psi in front tires and 10 psi rear tires.
1.6 Most Briggs, Kohler, Kawasaki, and Vanguard engines hold one (1) quart of motor oil.
1.7 3 Cylinder Caterpillar engines hold four (4) quarts of motor oil and 4 Cylinder Caterpillar Engines
Hold five (5) quarts.
Warranty Registration
The Warranty Registration form must be completed and signed to validate your warranty. As the new
equipment owner, you are expected to see that the form is completed and forwarded to Bad Boy, Inc.,
at time of delivery.
Model/Serial Number
Lightning, Pup, AOS, Diesel model serial numbers are found on the SIN plate, located underneath
the floor panel. ZT and MZ model serial numbers are found on the SIN plate underneath seat. The serial
numbers are necessary on the warranty registration form. Also, these numbers can assist you in the
ordering of new parts when replacements become necessary.
Parts/Service
Only Bad Boy replacement parts are to be used on your mower.
Replacement parts are available through your local Bad Boy Mower Dealer. Remember to always provide
the following information when ordering parts:
1. Correct part number
2. Correct serial number
All warranty repair and service must be handled through your authorized Bad Boy Mowers dealer. To
locate the nearest dealer, go to our website and click on Locate a Dealer.
PAGE 4
To Next Page
Loading...
Need help?
General
