EasyManua.ls Logo

Bad Boy OUTLAW User Manual

Bad Boy OUTLAW
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ZERO-TURN MOWER
OWNERS, SERVICE & PARTS MANUAL
For additional information, please see us at
www.badboymowers.com
Bad Boy, Inc.
102 Industrial Drive
Batesville, Arkansas 72501
©2014 11-1
OUTLAW &
OUTLAW EXTREME MODELS
Question and Answer IconNeed help?

Do you have a question about the Bad Boy OUTLAW and is the answer not in the manual?

Bad Boy OUTLAW Specifications

General IconGeneral
TransmissionHydrostatic
Deck MaterialSteel
Engine ManufacturerKawasaki
Warranty3 years
Cutting Width54 inches

Summary

Basic Information

Mower Safety Guidelines

General Operation Safety

Read manual, clear moving parts, use caution during operation.

Slope Operation Safety

Requires extra caution; avoid steep slopes and sudden movements.

Child Safety Precautions

Keep children out of mowing area; never allow them to operate.

Mower Operation

Pre-Operation Checks

Place brake, ensure drive arms are open, PTO off before starting.

Starting the Mower

Insert key, start engine, disengage choke, increase RPM.

Operating Tips and Best Practices

Familiarize controls, start slowly, be cautious on inclines.

Mower Maintenance Schedule

Troubleshooting Guide

Uneven Cutting Pattern Solutions

Check tire pressure, blade sharpness, deck cleanliness, throttle.

Mower Starting Issues

Check battery, fuel, spark plug, air filter, and fuses.

Blade Engagement Problems

Verify seat safety switch and PTO engager connection.

Mower Controls Overview

Mower Blade Maintenance

Blade Inspection and Sharpening

Check after use, keep sharp for clean cut, replace if damaged.

Blade Handling Safety

Never work with engine running, use gloves, use blocks under mower.

Mowing Tips and Techniques

Mowing Pattern and Height

Use header strips, mow at proper height, avoid scalping.

Service and Maintenance

Hydrostatic System Service

Change filter, use 20W50 oil, check reservoirs per schedule.

Drive Belt Maintenance

Adjust belt tension using jam nuts; factory setting is .030".

Engine Service and Filters

Change oil/filter at 50 hrs or yearly, check air filter.

Electrical System Checks

Inspect fuses, ground cable, relays, and charging wire voltage.

Cutting Deck Adjustment and Leveling

Ensure deck is level with slight forward tilt for optimal cut.

Limited Warranty Information

Warranty Registration Process