"M" (manual) :
●
When shifting the shift lever from "D" to "M",
the transmission will enter the M gear mode,
and the dashboard will display the current actual
gear M, push forward and backward through the
shift lever, and then enter the manual mode, and
the dashboard will display the corresponding
actual gear.
Driving operation:
●
Press the brake pedal to the bottom, put the
shift lever in P/N, and start the engine.
●
Step on the brake pedal, put the shift lever
into "D" and enter the normal shift procedure.
●
After the vehicle is put into gear, the
electronic parking brake is released first, and
then the brake pedal is released and the
accelerator pedal is pressed slowly. The vehicle
can start to drive.When parking, press down the
brake pedal, stop the vehicle, apply parking
brake, and put the shift lever into "P" gear.
Caution
●
According to the change of resistance (such
as traction, climbing a long slope, etc.), the
vehicle will start the corresponding gear shift
process, by changing into a lower gear to
provide greater power to the vehicle.This
prevents frequent gear changes.
●A cold engine starts at a high speed, so be
careful when you put it into "D" or "R"
before the engine warms up.
●
Before starting the engine, make sure the
gear is in "P" or "N". Do not try to start the
●
Put the shifter lever in its other gear from
"N", leaving the engine idling.
●When driving in manual mode, the vehicle
will not automatically shift up. Please also
pay attention to the speed and load of the
vehicle to shift up timely, otherwise the
engine and automatic transmission will be
damaged.
●When the car is being towed, remove the
drive wheel from the ground.
To Next Page
Loading...