Install Fuse Box
1 Check and ensure the steering column had
adjusted the lowest position. The knee
protection cover is with a protection cover
2 Install knee protection cover plate, from
bottom to top, to forward force by left and right
sides at the same time.
3 Rip cover nonwovens.
Engine Compartment Power
Distribution Center
The engine compartment power distribution
center is located at the front end of the
battery.
Check and Replace Fuse
If a certain electrical device stops working, you
should check whether it is caused by fuse
damage. You may follow the graphs of Engine
Compartment Power Distribution Center the
position map on the fuse box cover and tables to
determine the one or several fuses that control
the component. Before you are able to
determine whether the fault is caused by fuse
damage, you may replace all damaged fuses and
check if electrical devices can work normally. If
the fault still exists, please contact an authorized
BAIC dealership.
Pull out the fuse of the electrical device which
has stopped working, and check it out.
Find the melted metal wire in the fuse. If the
fuse has melted (the fuse in the place of the
arrow in the figure has been disconnected), be
sure to use a spare fuse of the same or lower
amperage to replace it.
If no spare fuse can be used and the vehicle
cannot be moved as a result, a fuse of the same
or lower amperage may be removed from
another circuit to make
To Next Page
Loading...