The memorial function of angular position for
the side mirror lens *
Set the side mirror position:
1. Adjust the driver’s seat and side mirror to the
desired position.
2. Press the SET key, and then press any of the
memory position buttons 1, 2 or 3 within about 5
seconds for about 1 second. The position is
memorized successfully and a prompt interface
appears on the instrument.
If the above operation is carried out again, when any
button ("1", "2", or "3") is pressed, the previously
recorded position of any button will be overwritten
with the current position.
Call the memory location:
The seat and side mirror will move to the memory
position if the corresponding memory position button
(1, 2, 3) is pressed.
The right side mirror reverse automatically rolls
down *
When the Start/Stop button is switched to the "RUN"
mode position and the gearshift handle is in R gear
and the speed is lower than 20 km/h, the right side
mirror will follow to the memory position. When the
START/STOP button is switched to non-RUN mode
or the gearshift handle is in non-R gear or the vehicle
speed is greater than 20 km/h, the right side mirror is
adjusted to the required angle for normal driving.
This function can be turned on/off by infotainment
screen > > vehicle settings > side mirror reverse
tilt setting, and the side mirror reverse tilt position can
be set.
To Next Page
Loading...
