EPS
The EPS can provide turning effort under various
driving conditions according to different vehicle
speed and turning wheel torque during vehicle
turning, and reduce the disturbance to the turning
system caused by rough road. It can not only reduce
the turning control at low speed, but also greatly
improve the handling stability at high speed.
When driving at parking or very low speed, if the
turning wheel is continuously operated for several
times or the turning wheel is operated with high
torque for a long time (the turning operation is still
carried out at the turning wheel limit position or when
the wheel is stuck, it is necessary to avoid prolonged
operation), the EPS system will reduce the turning
effort to prevent the system from overheating and the
operation of the turning wheel will become more
laborious. If you continue this operation, the EPS will
enter overheat protection mode, the assist will
decrease, and the hand force will gradually increase,
but the EPS indicator light will not go on. The turning
shall be stopped until the temperature drops and the
assistance will automatically resume.
When the engine is running, the EPS indicator light
is on (yellow light: some functions are affected or the
assist is gradually reduced; red light: cut off the
assist), indicating that the EPS is not working
properly. Please contact the authorized dealership of
BAIC ORV to check the EPS.
● When the turning system fails, please
contact the authorized dealership of BAIC
ORV immediately for inspection and repair.
Even if you don't notice anything unusual
during the turning, the system may have had
a serious problem causing the turning to
malfunction.
● After the turning column and turning gear
are replaced or the vehicle four-wheel
alignment is done again, the angle sensor
SAS shall be calibrated in the neutral
position, otherwise the vehicle will deviate
and the alignment function will fail.
Setting of Assist Mode
Press the keyless Start/Stop button to "RUN" mode,
via infotainment screen > > vehicle settings >
turning settings, switch the turning modes, including
easy, standard and sport.