"R" position (reverse gear):
● When shifting into "R" position, make sure that
the vehicle has stopped completely. When
shifting into "R" position from "N", "P" or "D"
position, you must press the brake pedal to the
bottom and press the unlock button of the
gearshift handle. Push the shift handle forward to
the first or second gear before shifting into "R"
position. When shifting into "R" position, "R"
position will be displayed on the dashboard and
the gearshift handle, and the backup lamp will be
lit automatically.
"N" position (neutral):
● Select "N" position when the vehicle is
completely stationary and the engine needs to idle
for a short time (e.g., waiting for a traffic light).
When in the "N" position, the "N" position will be
displayed on the dashboard and gearshift handle.
The transmission is not locked and the parking
brake must be used or the brake pedal must be
pressed.
"D" position (driving gear):
● Generally the "D" position is used when the
vehicle is driving forward, which will be
displayed on the dashboard and the gearshift
handle. The system will automatically switch to
the high or low speed gears according to the
engine load and the vehicle speed.
"M" position (manual):
● Only when the current gear position is "D"
position, push the shift handle to the right to the
manual mode position, and the automatic
transmission will enter the "M" position.
Meanwhile, the dashboard will display the current
actual gear position which is M position, and the
"M" position will be displayed on the gearshift
handle. At this time, you can push the shift handle
forward and backward to manually upshift or
downshift, and the instrument panel will display
corresponding actual gear position.
● If the gearshift handle is pushed to the right to the
manual mode position in the "P", "R" or "N"
position, the automatic transmission will remain
in the original gear position at the same time, and
the vehicle will display a prompt message on the
dashboard and give a prompt sound, prompting to
push the gearshift handle to the left.
● If the automatic transmission switches to the "P"
position after shutting down the engine in the "M"
position, be sure to push the gearshift handle to
the left center position at this time, otherwise the
engine will not be started again, and the vehicle
will display a prompt message on the dashboard
and give a prompt sound, prompting to push the
gearshift handle to the left.
Driving operation:
● Press the brake pedal to the bottom and the
vehicle is engaged to P/N gear before starting the
engine.
● Press and hold the brake pedal, press the unlock
button, and shift to "D" position,
● After engaging in gear position, release the EPB
first, then release the brake pedal and slowly press
the accelerator pedal, and the vehicle can start.
When parking, step on the brake pedal, stop the
vehicle, apply parking brake, and hook the
vehicle into the "P" position.
To Next Page
Loading...
