● The vehicle will start the corresponding gear
shifting according to the change in resistance
(such as towing, climbing a long slope, etc.),
and provide more power to the vehicle by
switching to a lower gear position. This
prevents frequent gear shifting.
● The RPM of the cold state engine is very high
when it is just started, so please be careful
when shifting into "D" position or "R"
position before the engine is warmed up.
● Before starting the engine, make sure the
gear position is in "P" position or "N"
position. Do not try to start the engine in
other gear positions.
● When shifting the gearshift handle from "N"
position to other gear positions, keep the
engine at idle.
● After the engine is turned off in "M"
position, the transmission will automatically
switch to "P" position. Be sure to push the
gearshift handle to the left position to avoid
affecting the next start.
● The transmission will switch to the "P"
position automatically when the engine is
turned off. Be careful not to turn off the
engine when the transmission "N" position
is in use (e.g. vehicle wash device, towing
trailers, etc.).
● When the engine cannot be started or must
be shut down, if you want to put the
transmission in "N" gear, use the "P"
position, and the emergency unlock
mechanism will forcibly unlock and switch
the transmission to "N" position.
● When driving with a manual mode, the
vehicle is forced to upshift only when the
RPM is too high. Please also pay attention to
the speed and load of the vehicle to upshift in
time, otherwise the engine and automatic
transmission will be damaged.
● When the vehicle is being towed, please lift
the drive wheels off the ground.
Automatically switch to "P" position when:
● When the vehicle stops moving, the
automatic transmission is in the R/N/D/M
gear position, and the engine is turned off;
● If the gear D/M/R/N is switched in the stop
state, open the driver door and release the
brake pedal.
To Next Page
Loading...
