4L: four-wheel drive low gear and four-wheel drive
can be used for a short period of time on off-road
surfaces that require high traction at low speed, and it
is not allowed to be used on dry or paved roads.
Shift the gear
Switching between 2H and 4H:
When the vehicle is running (the speed is less than 60
km/h), the driver can switch between 2H and 4H at
will without stopping the vehicle, but it shall be
carried out at a constant straight speed.
Switching between 4H and 4L:
1. Stop to keep the engine in state;
2. Move the transmission control handle to the N
position;
3. Rotate the transfer case gear shifting switch to 4L
or 4H position.
The "4L" position in the lower left of the instrument
cluster display shows the current gear position of the
time-sharing four-wheel-drive transfer case.
● In order to avoid the failure of transfer case
parts caused by misoperation, the electronic
control transfer case of this model does not
support the vehicle of retrofit clutch!
● When in 2H position, the instrument light
does not light up.
● When the transfer case is shifting the gear,
the current gear position is always on and
the target gear position flashes. If the gear
4H is switched to the gear position 4L, the 4H
light on the instrument is always on, and the
gear 4L flashes. After the gear shifting is
completed, the 4H light goes out and the 4L
light is always on.
● If the transfer case gear position is not fully
engaged, the transfer case may be damaged
or the vehicle may lose power and control,
resulting in personal injury.
● Do not drive on dry and hard roads for a
long time in the 4WD mode.
● If abnormal vibration of the chassis is found
during turning, please first check whether
the transfer case is not set to "2H".
● Use the "4L" gear position only when extra
tow is required, and do not use the "4L" gear
position for a long time.
● The speed shall not be higher than 60km/h in
4H mode; The speed shall not be higher than
30 km/h in the 4L mode.
To Next Page
Loading...
