Introduction to intelligent driving assistance
Introduction to intelligent
driving assistance
The Intelligent Driver Assistance System can actively
monitor the road conditions around the vehicle and
realize assistive driving.
Intelligent driving assist system sensor position
①
Front camera *
②
Rear corner mmWave sensor sensor *
● If the front windshield window or bumper
needs to be replaced, please send the vehicle
to the authorized dealership of BAIC ORV.
This ensures proper handling, installation
and mmWave sensor sensor of the camera.
Otherwise, some functions of the intelligent
driving assist may fail.
● To ensure that the various components of the
Intelligent Driver Assistance system provide
the most accurate information possible, they
shall be kept clean, unobstructed and
undamaged. Occasionally, wipe the parts,
and bumper and windshield on the outside of
the parts with a piece of soft cloth that is
dipped in warm water, so as to remove dirt
and ice on them.
● Do not use corrosive or abrasive cleaning
agents.
● Do not clean the camera lens with sharp or
abrasive objects to avoid scratching or
damaging the lens.
● Do not use high-pressure cleaner.
Special precautions for the use of mmWave
sensor sensor:
According to the Provisional Regulations on the
Management of Automotive Sensor Sensor
Radio, in order to protect radio astronomy
services operating in the same frequency band,
it is prohibited to use automotive sensor sensor
in the frequency band 76-79 HZ within the
vicinity of the radio observatory site. The
specific locations and prohibited scope are as
follows:
● The radio observatory at Xiaoyematan,
Zelinggou, Xuji Township, Delingha City,
Haixi Mongol and Tibetan Autonomous
Prefecture, Qinghai Province is 26 km from
the automotive sensor sensor.
To Next Page
Loading...
