Display interface
The display state of lane marking identification and
system interface are as follows:
● The lane marking is not displayed when it is
unrecognized.
● The lane marking is white when it is identified
and the vehicle is not deviated.
● The lane marking is red when it is identified and
the vehicle deviates.
● The lane marking is green when the lane marking
is identified and turning intervention is activated.
When LKA is active, it exits when one of the
following conditions is met:
● The speed is less than 55 km/h or the speed is
greater than 150 km/h.
● ABS or ESC function is activated.
● Turn off the lane keeping assist switch in the
infotainment screen setting
● The lane markings on both sides are not visible,
or the lane is too wide/narrow.
● When the vehicle is in backlight, glare or
other environmental states, the LDA may
exit for a short time, or false alarms or
failure to alarm may occur. After a period of
time, the system will recover automatically.
Drivers are advised to drive with caution.
LKA sensitivity
The LKA sensitivity is divided into three levels: Low,
standard, high.
Conditions for LKA trigger suppression:
● The turning indicator light is turned on when the
vehicle deviates.
● ESC or ABS intervene.
● Crossing lane marking quickly and continuously.
● Driving on the line.
● Merger.
● Forced brake.
● Sharp turning (excessive turning rate).
● Press the accelerator sharply.
Off-road mode
To Next Page
Loading...
