● It is advisable to avoid sharp braking as
much as possible before removing the ice or
deicing salt attached to the brake, and
special caution should also be exercised
during braking to prevent traffic accidents.
● Ensure that relevant information and
warnings have been carefully read through
and followed before use.
● When wash the vehicle, pay special attention
to the bottom of the vehicle and the inside of
the wheel cover to avoid hurting your hands
and arms by sharp parts.
● Do not clean the vehicle directly into the
engine compartment, otherwise it will affect
the service life of various components and
parts in the engine compartment.
Waxing
Regular waxing can protect the body paint and keep
the vehicle body clean.
Only after the whole vehicle is wiped dry can the
waxing operation start.
A superior quality paint protection wax should be
selected.
To effectively protect the body paint, it is suggested
that a superior quality hard wax should be applied
once a year so as to protect the paint surface from
erosion by adverse external environment and protect
it from light mechanical scratches.
High quality wax type
Body wax:Wax which is used to protect the paint
surface from sunlight, air pollution and other adverse
external environments. It is usually used on new
vehicles.
Polish wax:It can restore gloss to those paint surfaces
which have been oxidized or have lost gloss. Mainly
used to restore the gloss of the paint surface.
Do NOT wax in a dusty environment.
Glazing
Polishing is needed only when the body paint
becomes unsightly and even waxing materials cannot
deliver good gloss. If the polishing agent used does
not contain an anti-corrosive ingredient, waxing
treatment must be performed.
Lusterless parts and plastics cannot be treated
with polishing agents or hard wax.
Body Paint Damage
Minor body paint damage (such as scratches, scrapes
or stone striking marks) should be covered with body
paint before they start to rust.
If they have already rusted, the rust must be
thoroughly removed. In addition, the rusted portion
must have an anti-corrosive base paint and a covering
paint spread over it. The work shall be done in the
authorized dealership of BAIC ORV.
To Next Page
Loading...
