EasyManua.ls Logo

BAIC BJ60 Series - Page 272

BAIC BJ60 Series
349 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
270
Engine oil
1
2
3
4
5
6
7
8
3. Pull out the oil dipstick to check the oil level,
which shall be in the corrugated area. If the level
is lower than the minimum mark, add engine oil
until the level reaches the upper middle of the
scale.
4. After filling the engine oil, keep the engine idling
for 2 minutes, and then stop it for 15 minutes to
view the oil level and check whether it meets the
requirements.
-F- is the engine oil maximum mark.
-L- is the minimum mark for engine oil.
The oil level should be located between the
maximum mark and minimum mark, otherwise
the engine might be damaged.
Engine running will consume a certain amount of
engine oil. The amount of engine oil consumed
depends on the driving style and vehicle use.
Therefore, it is necessary to regularly check the
engine oil level. Before adding fuel and driving long
distances, it is advisable to check the engine oil level.
When the vehicle runs long distances on the
expressway in summer, or towing a trailer, or
climbing along a mountain road, the engine runs
under harsh conditions, and the oil level must not
exceed the maximum mark -F-.
Engine Oil Refilling (Gasoline
Models)
Engine oil should be added by a small amount over
several times.
1. Park the vehicle on a level surface.
2. Turn on the engine compartment hood.
3. Press the oil filler cap and turn it
counterclockwise to open the oil filler cap.
4. To avoid filling excessive engine oil, fill a small
amount of engine oil each time, check the oil
level, and refill as oil level requires.

Table of Contents

Related product manuals