5. Once the oil level is close to the maximum mark,
please stop refueling immediately and install and
tighten the oil filler cap.
● Be sure to carefully read and observe the
relevant warnings before starting work.
● The engine oil is highly flammable. While
adding engine oil, be sure to exercise care. Be
careful to NOT spray engine oil onto any
engine part or the exhaust system.
● The engine oil filler cap must always be in
the tightening state to prevent the engine
from splashing and causing a fire when it is
running.
● Be sure to use the engine oil that is
appropriate for the engine of the vehicle you
purchased.
● If a different specification of engine oil is
used, the engine may be damaged and this
may lead to an accident.
● If the oil level exceeds the maximum mark,
do not start the engine; otherwise, the
catalytic converter and engine may be
damaged.
● Engine oil that meets SP grade or higher in
API grade shall be filled.
● The engine of the vehicle is filled with high
quality engine oil at the factory and can be
used all year round, except in extreme cold
weather.
● Do not mix engine oil of different grades.
Engine oil replenishment (diesel
models)
Engine oil should be added by a small amount over
several times.
1. Park the vehicle on a level surface.
2. Turn on the engine compartment hood.
3. Press the oil filler cap and turn it
counterclockwise to open the oil filler cap.
4. To avoid filling excessive engine oil, fill a small
amount of engine oil each time, check the oil
level, and refill as oil level requires.
To Next Page
Loading...
