BAIC BJ60 Series - Page 279

Coolant
277
1
2
3
4
5
6
7
8
Open the cover of the engine
coolant expansion tank (take the
engine coolant expansion tank as an
example)
The engine must not be running.
To avoid burnt, wrap the coolant recovery reservoir
cover with a piece of large and thick cloth, and
uncover it counterclockwise as indicated by the
Arrow.
Hint
The coolant expansion tank cover should be
opened when the engine is in a cold state.
Filling of Coolant
Only new coolant can be added.
After filling, the coolant level must be located
between “MIN” line and “MAX” line.
Note
The fluid level must not exceed the upper mark
line of "MAX".
Closing the Coolant Expansion
Tank Cover
Mount and tighten the expansion tank cover.
Hint
When the engine is in a hot state, the coolant
level may be slightly higher than the upper limit
mark.
Note
● It is recommended to fill coolant when the
engine is cold state, but the coolant level shall
not exceed the maximum mark, otherwise
excess coolant will overflow when the engine
is hot state.
● Only new coolant can be filled when adding
coolant. The coolant must comply with the
provisions of this Manual. If suitable coolant
cannot be purchased at this time, no other
coolant may be added. If necessary, pure
water may be temporarily added. However,
coolant must be added as soon as possible in
accordance with the provisions.
● If the coolant loses much, the cold state
coolant shall not be added until the engine
cools down. Otherwise the engine may be
damaged. If there is a large loss of coolant, it
indicates a leakage fault in the cooling
system. At this time, it is necessary to go to
the authorized dealership of BAIC ORV to
inspect the cooling system as soon as
possible, so as not to damage the engine.