Sunroof closed
When Keyless Start/Stop button is in "RUN" mode:
● Move the Sunroof switch ① forward and the
sunroof starts to slide forward from the slide to
open position to close.
● Press and hold the Sunroof switch ① forward,
and the sunroof starts to slide forward from the
slide to open position to close. During operation,
move the sunroof switch backward again, and the
sunroof stops sliding.
● When both the sunroof and the sunshade are
turned on, press the Sunshade switch ②
forward to turn off the sunroof first.
● Repeated opening and closing of the sunroof
may cause the sunroof thermal protection to
stop working. Do not operate the sunroof
repeatedly.
Electric sunshade
The sunshade can be opened together with the
sunroof.
The Start/Stop button is on the "RUN" mode. When
the sunroof is in the off state, move the Sunshade
switch
②
backward, the sunshade will open
automatically. During the opening of the sunshade,
move the Sunshade switch
②
forward and the
sunshade will stop at the current position.
The Start/Stop button is on the "RUN" mode. When
the sunroof is off, move the Sunshade switch
②
forward, the sunshade will be off automatically.
During the closing of the sunshade, move the
Sunshade switch
②
backward and the sunshade will
stop at the current position.
● Do not forcibly close the sunshade when the
sunroof is open.
Self-learning of sunroof initialization
Before the sunroof initialization, ensure that the
sunroof is in the following state to ensure that the
initialization can be completed properly.
1. The sunroof is in the closed state.
2. Close the sunshade to the front end and visually
check that the gap between the front end of the
sunshade and the sunroof frame is even (about
2mm). An abnormal sunshade shutdown may be
caused by an abnormal initial position, which can
be done as follows.
- If the sunshade stops in the middle of the
closing process, press and hold the sunshade
switch forward and long until it is turned off.
- If the sunshade suddenly rebounds at the front
end, pull the sunshade switch forward for a
long time while bouncing until it closes.
3. The vehicle voltage is stable.
Operation of initialization:
1. Push the sunroof switch forward for a long time
until the sunroof motor and sunshade motor shake
a little, and then release it for 1~2 seconds.
To Next Page
Loading...
