Instrument and control system 71
D50
2
Operation system and specification
Warning
●Turning on the ESP system during
normal driving can help improve the
comfort and safety of the vehicle, but be
cautious when driving on corners and
slippery roads!
Low beam light indicator D
(green)
Indicates the low beam operation status and
lights up when the high beam low beam is
turned on.
High beam light on indicator o
(blue)
Indicates the high beam operation status and
lights up when the high beam is turned on.
Parking Brake Indicator / EPB Work Status
Indicator II (red)
When the start/stop button is in the “RUN”
mode, this light is illuminated for self-test and
annihilated after self-test.
Configured as mechanical parking:
Indicates the status of the parking system. When
this light is on, it indicates that the mechanical
parking has been pulled up.
Configured as an EPB parking:
Indicates the working status of the EPB. When
this light is on, it indicates that the EPB parking
function has been turned on.
Left turn indicator II (green)
Indicates the left turn signal operating state.
When the left turn signal or hazard warning
light is turned on, the indicator flashes at 1 Hz.
If the indicator flashes faster than normal, it
indicates that the left turn signal is faulty.
Please check the repair at the nearby 4S shop as
soon as possible.
Right turn indicator o
(green)
Indicates the right turn signal operating state.
When the right turn signal or hazard warning
light is turned on, the indicator flashes at 1 Hz.
If the indicator flashes faster than normal, it
indicates that the right turn signal is faulty.
Please check with your nearest 4S shop as soon
as possible.
Driver seat belt is not equipped with warning
light A (red)
This light indicates the driver's side seat belt
status, which lights when the driver is not
wearing a seat belt
。
When the vehicle speed is km25km/h or the
vehicle continues to travel for
秒
60 seconds or
the vehicle continues to travel distance
彡
500m, when the driver's seat belt is not attached,
the driver's seat belt does not flash the warning
light at 1Hz, accompanied by an audible alarm.
The same time, the seat in the corresponding
position in the alarm pop-up window turns red
and flashes according to 1HZ (7-inch meter).
When the driver does not wear the seat belt, the
buzzer reminder will end after 120 seconds, and
the alarm light will continue to light. The
alarm sound will not be triggered again when
the seat belt is not attached or during a key
ignition cycle.
To Next Page
Loading...
Need help?
General
