3. QUICK START GUIDE
3.1. PLUTO SETUP
Use the following workflow to get started:
1.
Connect the 2.5mm headphone stereo plug to the Pluto Trigger camera port
located next to its USB port. Connect the camera plug to the camera shutter
release port. You may want to consult your camera user manual on where
the shutter release port is located.
2. Turn Pluto Trigger on by sliding the power switch to the right. The Status Led
should blink for three times, indicating system starts.
3. Make sure Bluetooth on Pluto Trigger is turn on. Bluetooth is on by default. But
if it was turned off accidentally, you can toggle the Bluetooth state by
pressing and hold the shutter release button on Pluto Trigger for 5 seconds.
When Status Led emits three short blinks, Bluetooth is turned on. while one
long blink means Bluetooth is turned off.
3.2. CAMERA SETUP
Your camera may also require a minor set up process prior to using the Pluto
Trigger. We recommend the following camera settings to get the most out of your
Pluto Trigger:
1. Turn your camera on.
2.
Set your camera to Manual Exposure mode unless recommended otherwise.
3.
Set your camera to Manual Focus mode unless recommended otherwise.
4.
Set your camera to Single drive mode. Operating your camera in Continuous
drive mode with Pluto Trigger may lead to unexpected results, such as extra
pictures being taken. Alternatively, you can use Quiet or Silent drive mode, if
available on your camera. With Quiet or Silent drive mode the frame rate
may be slower, but shutter will generally sound more quiet and soft, which
may be preferable in certain situations.
To Next Page
Loading...